Specifications

Locate the sliding carriage table (D) and slide it onto the carriage arm (V), see fig 10. Using

a level or straight edge place across the sliding table (D) and the saw bench (A), fit the four

M6 x 30mm Hex bolts to the underside of the carriage support arms (B) and adjust until the

sliding table (D) is level with the saw bench. (See figs 11 & 12).

Place an M6 x 16mm hex bolt in each of the four clearance holes on both support arms (B),

and loosely put an M6 nut and washer on the bottom of each. (See fig 8). Slide the

extruded carriage arm (V) onto the four M6 x 16mm bolts. (See fig 9).

Two M6 x 30mm hex bolt

M6 x 16mm hex bolt

Assembling the Sliding Carriage Table

When both the tables are level tighten the four M6 nuts on the M6 x 16mm hex bolts

underneath the carriage arms (B), see fig 11. Lastly fit the carriage arm end stops (K) to

each end of the carriage arm (V). (See fig 13).

Fig 8

Fig 9

Fig 10

Fig 11

Fig 12

Fig 13

M6 x 16mm bolts into each of the four

clearance holes in both support arms

Slide the extruded carriage arm onto the

four M6 x 16mm bolts

Assembly Instructions