Specifications

Assembly Instructions

Angle Fence Assembly

To set the angle fence (W) to angles between 45˚ and 90˚ loosen the three lift and shift

handles on the connecting & work clamp blocks (O) and the fence to the required angle on

the scale on the sliding carriage table (D). (See figs 22). Tighten the three lift & shift

handles to lock the angle fence in position. Note: The fence can also be used at the rear

of the sliding carriage table if you prefer to push the timber against the fence.

Locate the flip over stop (M) and slide it into the T-slot on top of the angle fence (W).

(See fig 23).

Locate the mitre fence steel bar (B2), mitre fence (E) and clamping knob (G). Slot the

threaded pin on the steel bar (B2) through the curved slot in the mitre fence (E) and screw

the clamping knob (G) to clamp the assembly together. (See figs 24 & 25). Slide the Mitre

fence assembly into the machined T-slot on the saw table. (See fig 26).

Fig 20

Fig 21

Fig 22

Fig 23

Fig 24

Fig 25

Mitre Fence Assembly

Continues Over....