Specifications

Assembly Instructions

Locate the two extension table support arms (X). Remove the plastic cover to the left hand

side of the support arm with the scale. (See fig 32). Slot the extension table support arm (X)

onto the M6 nuts so that nut sits in the T -slot. (See fig 33) Push the support arm so it is

flush with the end of main table and lightly secure the extension support arm to the main

table using a phillips screwdriver. Replace the plastic cover you removed earlier. (See figs

34 & 35). Repeat for the other extension support arm.

Put to hand six M6 x 16mm Phillip head screws with square nuts (Z3), remove the nuts and

place safely aside. Slot the screws into each of the 6 holes on the extention table lip (Y),

replace the square nuts (Note: Leave a gap between the base of the extension table

lip and nut) (See figs 36 & 37).

Fig 32

Fig 33

Fig 34

Fig 35

Fig 36

Fig 37

Lightly secure the extension arm to the

main table with a Phillips screwdriver

Replace the plastic cover to the end

of the extension arm

Extension Table Assembly Part 2

Plastic Cover

Continues Over....