Specifications

Assembly Instructions

Extension Table Assembly Part 2

Fence Assembly

Remove the plastic covers from the ends of the two extension table support arms (X), (see

fig 38). Offer up the M6 nuts to the support arms T-slots and slide the extension table (Y)

into the extension support arms (X). Push the extension table (Y) until it is flush up against

the main saw table, place six Phillips screws into the captive nut locations (a), place a level

between both tables, adjust the screws (a) until both tables are level & tighten the six M6

Phillips screws & square nuts (b) to clamp the extension table to the supporting arms.

Replace the plastic covers you removed earlier. (See figs 39,40 & 41).

Locate the fence clamp assembly (N) and fence (Z) Slot the steel square clamp into the

T-slot to the end of the fence (Z) and tighten the bolt using a 10mm socket/spanner.

(See figs 42 & 43).

Fig 38

Fig 39

Fig 40

Fig 41

Using a Phillips screwdriver level & tighten

the Phillip screws to clamp (X & Y)

Extension table assembled

Plastic Cover

T-slot

M6 x 16 Phillip

screw & square nut

Fig 42

Fig 43

Steel square clamp 10mm SocketT-slot