Specifications

Assembly Instructions

Fence Assembly

Lower the fence assemby so the clamp assembly (N) slots over the extention table support

arm (X), clamp the fence assembly in position by turning the knob clockwise. (See figs 44 &

45).

Note: Check that the fence is parallel to the saw blade by sliding it up against it. If the fence

is out of alignment loosen the steel square clamp bolt beneath the clamp assembly (N) and

adjust until correct, re-tighten the bolt. (See figs 43 & 46).

Note: Lubricate the Fence supporting arm (X) and the underside of the clamp assembly (N)

so the fence assembly runs smoothly back and forth.

Locate the 50 & 30mm hoses (Z1), jubilee clips (Z2), dust extraction moulding support

bracket (I) & 100mm dust extraction moulding (L). Place one of the large jubilee clips over

the end of the 50mm hose and fit the hose over the table saw’s dust extraction outlet &

tighten. (See fig 48). Do the same as before & place the 30mm hose over the end of the

saw guard’s dust extraction outlet (U) & tighten. (See fig 49).

Fig 44

Fig 45

Fig 46

Fig 47

Fig 48

Fig 49

Dust Extraction Assembly

Continues Over....

50mm hose

30mm hose