Specifications

Setup & Adjustments

Fig 54

Fig 55

Fig 56

Fig 57

Fig 58

Fig 59

Adjusting the Riving Knife

Adjusting the Fence to the Blade

Raise the saw blade to its highest point and remove the saw blade guard. Remove the four

hex screws and place carefully aside, remove the table insert. Using the spanner provided

loosen the riving knife and adjust until the tip of the riving knife is 3mm away from the saw

blade & re-tighten. (See fig 54).

NOTE: Check that the riving knife is parallel to the saw blade by placing the fence

up against them. (See fig 55).

The fence assembly must be parallel to the saw blade for producing accurate cuts. Firstly

loosen the fence clamp assembly knob (N), slide the fence until it reads “ZERO” on the

table support arm scale (X). (See figs 56 & 57).

“Zero”

NOTE: Use the ‘T’ slot to the right side of the saw blade as a reference to check the fence is

parallel. (See figs 58 & 59). Regularly check the fence is parallel to ensure a perfect cut.

“T” Slot

Continues Over....