Owner`s manual

OWNER’S MANUAL
Page - 20 -
Adjust the nut gap on the carriage see Fig. 7. Rotate the p.1 on the nut to
satisfied saddle moving and required travel.
Chuck and faceplate mounting see Fig. 8. The connection between spindle
and chuck or faceplate is made by D-Cam lock structure. When mounting, put
the three pull pins of chuck or faceplate into the three holes on the spindle face
end, then turn the three cams with the aid of square head wrench, when
turning the cams clockwise, the chuck or faceplate will be locked, when turning
the cams counter-clockwise to certain point, the chuck or faceplate can be
detached.