Owner`s manual

OWNER’S MANUAL
Page - 5 -
TEST PROTOCOL
No. Diagram of measuring method Inspection item Tolerance Data
G1
a. Alignment of
longitudinal bed slide
ways in vertical place
Full travel
0.25 (+)
b. Parallelism of
transverse direction
1000:0.06
G2
Parallelism of
tailstock to
longitudinal motion of
carriage.
a. In vertical plane
b. In horizontal
plane
a. 500:0.03
b. 500:0.025
G3
Spindle nose run out 0.015
G4
Spindle taper run out
a. At the end of
spindle nose
b. At the end of
300mm test bar
a. 0.01
b. 300:0.03
G5
Parallelism of spindle
center line to
longitudinal motion of
carriage
a. In vertical plane
(upward)
b. In horizontal
plane (forward)
a. 300:0.02
b. 300:0.02