Owner`s manual

OWNER’S MANUAL
Page - 8 -
1. GENERAL DESCRIPTION OF THE MACHINE
1.1. GENERAL DATA
MAIN ASSEMBLIES (See Fig. 1a)
1. Bed way
2. Headstock
3. Feed box
4. Carriage box
5. Electrical box
6. Chuck protecting cover
7. Splash guard
8. Lower carriage
9. Top carriage
10. Cooling
11. Working light
12. Tailstock
CONTROLS (See Fig. 1b)
1. Lever for starting, stopping and reversing the carriage feed movement
while threading
2. Lever for spindle speed stages
3. Wrench for the tool-holder
4. Flywheel for shifting the tool-holder slide
5. Handle for tail-spindle fixing
6. Handle for tailstock fixing
7. Flywheel for tail-spindle shifting
8. Handle for starting or stopping of the carriage longitudinal shifting while
threading
9. Lever for starting the spindle in forward or reverse stroke and its stopping.
When shift in forward direction, the spindle will turn counter-clockwise, and
when shift in backward direction, the spindle will turn clockwise. When in
the center position, the spindle stopped.
10. Lever starting and stopping the carriage transverse and longitudinal
shifting.
11. Flywheel for manual shifting of the carriage in longitudinal direction
12. Flywheel for feeding the cross slide
13. Drum (handle) for selection of “feed” or “thread”
14. Button-emergency stop
15. Switch-coolant pump
16. Button-test bottom for the main el. motor
17. Signal lamp. It glows when the main el. motor is switched on
13. Leads crew (with Guard)
14. Feed rod
15. Switch rod
16. Tool holder
17. Quadrant
18. Oil tray
19. Steady rest
20. Foot stand
21. Thread indicator
22. Foot brake
23. 3 jaw chuck