User manual

Operating Instructions...

D.R.O. Control

Digital Read Out (DRO) (Fig 5)

For normal drilling operations press the ON/OFF switch first, and then press the “ZERO” button. Press

“mm/in” button to select metric or imperial readings. These two buttons can be effected regardless of the

down feed handle position, then you can start drilling. The readings on the display can be amended at

any time by pressing “plus” or “minus” buttons.

When displaying error (e.g. no readings or flashing) it means the batteries are low and need replacing.

Push against the arrow showing in (Figs 5a & 5b) to open the battery cover, withdraw the battery for

replacement. The voltage of the Zinc button batteries is 1.2 volts. After replacement, re-fit the cover.

1.2 volt zinc button batteryRemoving battery cover

Plus & Minus

The readings on the display

can be amended at any

time by pressing “plus” or

“minus” buttons.

Min/in

Press “mm/in” button to

select metric or imperial

readings.

On/Off

For normal drilling operations

press the ON/OFF switch first,

and then press the

“ZERO” button.

Digital display

Fig 5

Fig 5a

Fig 5b