User manual

Specification...
Axminster No.
600858 (Super X2)
Motor: Input 230V 50Hz 750W
Motor Output: 500W
Drilling Capacity (ST 37): 13mm / M8
Face Milling Capacity: 30mm
End Milling Capacity: 16mm
Throat: 160mm
Distance between Spindle/Table: 320mm
Thread Pitch of Lead Screw: 2mm
Lead Screw Diameter: M14
Spindle Taper: MT-2 / M10
Spindle Speed: Variable 50-2500rpm
Speed Ratio: 1:2
Spindle Stroke: 60mm
Column Tilting Range: 45˚I / 30˚ r
Max. Table Stroke x-axis: 250mm
Max. Table Stroke y-axis: 160mm
Max. Table Stroke k-axis: 300mm
Max. Tapping Size (HT200): M8
Max. Tapping Size (45): M6
Max. Milling Diameter: ø30mm
Table Size: 130 x 500mm
Overall Size: (LxWxH) 610 x 610 x 780mm
Weight: 127kg
Basic Safety for Machine Tools...
USE RECOMMENDED ACCESSORIES
Consult the owner's manual for details of any manufacturer's accessories or contact your supplier for
details of recommended accessories. Follow the instructions that accompany the accessory. The
improper use of accessories may cause hazards. The fitting of non-recommended accessories may also
cause hazards.
CHECK DAMAGED PARTS
Before using the tool, a guard or other part that is damaged should be carefully checked to ensure that it
will operate properly and perform its intended function. Check for alignment of moving parts, breakage of
parts, mounting and any other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced. A parts list is to be found at the back of your
operator's manual.
NEVER LEAVE A MACHINE RUNNING UNATTENDED
ALWAYS turn power off. Do not leave machine until it comes to a complete stop.
DRUGS, ALCOHOL AND MEDICATION
NEVER operate tools whilst under the influence of drugs, alcohol or after taking medication.
USE THE CORRECT TOOL
Do not force a tool or attachment to do a job for which it was not designed. This is dangerous workshop
practice.
06