User`s guide

4. Loosen each setscrew 1/8 turn to allow the table to move.

5. While holding the setscrews from turning, tighten the lock nuts.

6. Test by turning the hand wheel. Loosen or tighten all the setscrews the

same amount until the table moves freely, but without play in the dovetail.

X-axis gib adjusting screws

Y-Axis Gib

The Y-axis gib provides adjustment for the mating dovetails on the base and

the saddle that provide the Y-axis (in and out) motion.

To adjust the Y-axis gib:

1. Loosen the two lock nuts on the right side of the saddle.

2. Slightly loosen both setscrews on the right side of the saddle.

3. Snug each setscrew equally. This will lock the saddle in position.

4. Loosen each setscrew 1/8 turn to allow the saddle to move.

5. While holding the setscrews from turning, tighten the lock nuts.

6. Test by turning the hand wheel. Loosen or tighten both setscrews the same

amount until the saddle moves freely, but without play in the dovetail.

Z-Axis Gib

The Z-axis gib provides adjustment for the mating dovetails on the column and

the head assembly that provide the Z-axis (vertical) motion.

To adjust the Z-axis gib:

1. Loosen the four lock nuts on the right side of the head assembly.

2. Slightly loosen all four setscrews on the right side of the head assembly.

3. Snug each setscrew equally. This will lock the head assembly in position.

4. Loosen each setscrew 1/8 turn to allow the head assembly to move.

5. While holding the setscrews from turning, tighten the lock nuts.

6. Test by turning the Z-axis coarse feed handles. Loosen or tighten all the

setscrews the same amount until the head assembly moves freely, but

without play in the dovetail.