SL600C & SL700C Petrol Hedge Trimmers SL600C Hedge Trimmer Part No: 211925 w w w. a x m i n s t e r. c o .
OWNER’MANUAL OF SL700C/SLP600C Preface Thank you for buying our hedgetrimmer. This manual is mainly about the proper method for operation, easy inspect and maintenance. Before operation, please read this book carefully and understand fully, so that this manual can be used best. Please read the manual carefully before using the machine, and save it for checking at any moment. Because the part structure of the product may improve, the product could be difference from the manual, please make allowances.
OWNER’MANUAL OF SL700C/SLP600C Contents Ⅰ. Warning labels on the machine… ……………………… ……………………… …………………3 Ⅱ. Correct use method ………………………………… …………………………………… ………………4 Ⅲ. Technical specification …………………………… ……………………………… ……………… ………8 Ⅳ. Main structure Ⅴ. Engine operation …………………………………… …………………………………………9 ………………………………… ………………………………………10 Ⅵ. Inspection ……………………………………………… ………………………………………………… …………………15 Ⅶ. Preparations for long storage .………… …………………… ……………………… ………………17 Ⅷ.
OWNER’MANUAL OF SL700C/SLP600C Ⅰ Warning labels on the machine 1、Read user’s manual 2 、 Wear gauze mask and protective glasses 3、Warning/Attention 4、The blade is sharp, prevent injury 5、Never use in the bad weather 3
OWNER’MANUAL OF SL700C/SLP600C Ⅱ Correct use method Before using this product，please make sure that you have first read this manual， use it in the proper method. In order to work best you should also follow the instructions of the warning labels . ■ Before using the machine ● Before using ， please read the user’s manual carefully ,and understand the caution rules completely . The blades are very sharp ,if operated wrongly it is WARI,I,G very dangerous.
OWNER’MANUAL OF SL700C/SLP600C ● Lack of sleep，tiredness or physical exhaustion results in lower attention spans ,and this in turn can lead to accidents and injury , limit the amount of time which the hedge-trimmer is to be used continuously to somewhere around thirty to forty minutes ,and have a rest time at least ten to twenty minutes . Also try to keep the total amount of work performed in a single day to a reasonable amount to prevent becoming overtired.
OWNER’MANUAL OF SL700C/SLP600C ignite the fuel. ● Smoking while operating the hedge-trimmer or refilling its fuel tank is extremely dangerous. Never operate like that. ● When refilling the tank always turn off the engine first and take a careful look around to make sure that there are no sparks or open flames anywhere nearby before refueling. ● If any fuel spillage occurs during refueling, use a dry rag to wipe up spills before attempting to start the engine.
OWNER’MANUAL OF SL700C/SLP600C ● While starting the engine make sure of the safety of your surroundings. ● The machine has a centrifugal clutch; the blades will not move when idle. Only when the engine speed is up to a certain level will the blades begin to move. WAR,I,G Please don’t put the throttle into the highest speed when starting. ■ ,otes of the operation ● Keep your hands tight on the handles, and keep the correct operating position.
OWNER’MANUAL OF SL700C/SLP600C not designed. Ⅲ Technical specification Model SL700C SLP600C 5 5.4 1160x240x240 1070x240x240 Single blade Double blade Total 19 Total 33 Net weight (kg) Overall dimensions(mm) type Shears Number teeth distance(mm) 35 Trimmed width(mm) 700 Rotation mode Centrifugal type clutch Reduction ration type 5.11 Air cooled 2 stroke gasoline engine model 1E34FSA power 0.75kw/7500rpm discharge(cc) Engine 600 25.4 fuel Mixed oil(25:1) Tank capacity（L） 0.
OWNER’MANUAL OF SL700C/SLP600C Because the product may be improved， ， part of the specification may be different from this manual . Ⅳ Main structure 1. Engine stop lever 7. Guard 2. Throttle rod 8.
OWNER’MANUAL OF SL700C/SLP600C 3. Right handle 9. Starter pulley 4. Fuel tank 10.Throttle interlock 5. Air cleaner 11. Throttle lever 6. Right handle 12. Handle Ⅴ Operation of engine ■ Fuel DA,GER ● The fuel is easily ignited, resulting in an accident, also if the refueling is ignited this will result in an accident. ● While mixing the fuel, it must be keep away from any source of spark, smoking not allowed.
OWNER’MANUAL OF SL700C/SLP600C ■ How to mix fuel IMPORTA,T Pay attention to agitation. ·Add suitable oil to the petroleum according to volume, the ratio is 25:1. ·Put some of the gasoline into a clean ,approved fuel container. ·Pour in all of the oil and agitate well. ! Agitating the fuel/oil mixture is important to the life of the engine. The use of an incorrect fuel/oil mixture will shorten the engine life considerably, sometimes damaging the engine beyond further repair.
OWNER’MANUAL OF SL700C/SLP600C When refueling, do not fill beyond eighty percent of the tank capacity, if you add too much, the fuel will IMPORTA,T leak from the tank, and possibly result in an accident. 1. Keep the machine when adding fuel/oil in the even place. 2. Loosen the tank lid，eliminate the pressure difference between the outside and inside. 3. Wipe up the tank lid，add the fuel/oil to eighty percent. 4. After finishing adding fuel/oil，tighten the tank lid ,make sure that there is no leakage.
OWNER’MANUAL OF SL700C/SLP600C When there is some fuel remaining in the tank， when the engine is still hot, if you wish to start it again ,it is no need to operate the primer button. 1. Put the choke lever on the carburetor to the closed position. 2. Put the machine onto even ground, at first pull the recoil handle slowly, when you feel some resistance，pull the recoil handle quickly . 3. After starting the engine，return the choke lever to the opened position . 4.
OWNER’MANUAL OF SL700C/SLP600C • DA,GER Do not use near any electrical wires. IMPORTANT During the using, if the blade has stopped，please operate as follows： ● The branches is too thick, please choose branches below 8mm. ● If the blade cutting is worsening : the blade maybe worn，the gap between the blades is too big decreasing the cutting ability. ● The blades are very sharp ， so they are very dangerous. If used the wrong way it will result in an accident，so you should always obey the manual .
OWNER’MANUAL OF SL700C/SLP600C While cutting branches, in order to be comfortable for the user， the double blade hedge-trimmer handle can be swivel through ninety degrees to the left or right. Proceed as follows: 1. Free the handle by pressing the locking lever，twist the handle to the desired way. 2. When the handle is the desired position，let go of the handle locking lever. 3．While the handle bracket has become fixed you can begin working. CAUTIO, Don’t use for trimming when the locking lever is pulled.
OWNER’MANUAL OF SL700C/SLP600C Ⅵ Inspection CAUTIO, ● While inspecting the product, first stop the engine. ● Please don’t change the body or remove the engine. ● Please use quality products and original parts when maintaining the machine. ■ Troublshooting 1 machine 2 throttle Problem A.loosening of an assembled part B.too big a gap between blades C. blade wear A. the lever is too slack B.
OWNER’MANUAL OF SL700C/SLP600C 3 Fuel tank 4 muffler A. has loosened in place B. fuel pipe is leaking C the tank lid is damage Loosening of assembly Tighten mounts Change Change Tighten mountings ■ Inspect in time Operating hours Items requiring attention 20h machine 50h 100h remarks ○ Cleaning the cylinder fan cover Clean the air cleaner filter net Clean and adjust the plug engine 25h ○ ○ Gap0.6-0.
OWNER’MANUAL OF SL700C/SLP600C the speed will not be stable. Change the filter promptly. ■ Spark plug Spark plug is easily have carbon deposit, after operating for twenty-five hours, remove it, and clean the electrodes with a steel wire brush. The suitable electrode clearance of the spark plug is 0.6～0.7mm. ■ Gear case After operating for twenty hours, you need to add grease to the gear case .Please use a grease gun on the nipple provided.
OWNER’MANUAL OF SL700C/SLP600C Ⅶ Instructions for long storage ● Long storage of the machine incorrectly may result in damage to the engine (shortage of power). IMPORTANT ● Do not tighten the tank cap too much, otherwise the sealing ring will be damaged. 1. While clean the machine, inspect every part whether it is damaged or loose, if found, repair it before next use. 2. Extract fuel from the tank and run off the engine until it stops naturally. 3.
1 OWNER’MANUAL OF SL700C/SLP600C
2 OWNER’MANUAL OF SL700C/SLP600C
3 OWNER’MANUAL OF SL700C/SLP600C
4 OWNER’MANUAL OF SL700C/SLP600C
SL600C & SL700C Petrol Hedge Trimmers 211925 & 211926 Axminster Reference No: SL600C Part No: 211925 SL700C Part No: 211926 Axminster Devon EX13 5PH UK FREEPHONE 0800 371822 www.axminster.co.
