Instruction manual

Specific Safety for Dust Extractors
7
Keep the particle filter clean. The machine relies on its
ability to ‘blow’ air through the filter, to generate good
suction. If the particle filter starts to clog, this reduces the
air flow and hence the machine becomes less efficient.
The particle filter can be cleaned, by removing the rear
filter cover and using a vacuum cleaner, clean the inside of
the filter.
Be aware that in dry air periods or areas, the movement of
the air through the machine can generate static electric
fields. These are not normally a problem as the machine
is bonded together via its construction and the whole is
earthed back through the electrical supply; problems can
occur with isolated items, such as stands or hosing that is
insulated from the ground.
• If possible, try to connect everything together
electrically, to eliminate static shocks.
• Use the integral metal coil in exible plastic hosing to
connect units together.
• Try to route the power cable and the hosing away from
busy walkways.
• Do not allow the inlet to become ‘dead ended’, or block
or restrict the outlet, this puts undue strain on the motor
and can lead to overheating.
NOTE: ALWAYS USE MANUFACTURERS WASTE BAGS WITH THIS MACHINE!
Model T-2000CK
Rating Trade
Power 0.75 kW (230V, 1ph)
Air Flow 1,100m³/hr
Noise Level 80 dB @ 3m
Filter Area 3.8m²
Filtration 1 micron
Particle Size 1 micron
Hose Diameter 150mm x 1, 100mm x 2
Overall L x W x H 1,300 x 1,100 x 1,560mm
Weight 71kg
Specification
Assembly Instructions
Please read through the section entitled Parts Identification and Description, this will enable you to more readily
identify those parts of the cyclone extractor.
Please note: some of this assembly procedure is best accomplished by two persons. Although
the tasks are not impossible, some of the items are heavy and awkward, and a mishandling
error could cause injury. Please think about what you are doing, your capabilities and your
personal safety. We have added the ‘two person symbol’ to any operation that we recommend
should be a two person task.
Unpack all the boxes and check all the components listed in the “What’s Included” section. If any parts or components
are missing, please contact our Customer Services Department using the procedures and telephone numbers listed in
our catalogue.
Please note: on occasions the packing list is not strictly adhered to. Please check all the boxes, packets
etc. to make sure that all the parts have been accounted for.
PLEASE RECYCLE ANY UNWANTED PACKAGING RESPONSIBLY!