Instruction manual

Assembly Instructions
9
Step 4 Locate the angle brackets (6), place the bracket flat
against the upper square tube (2), line up the pre-drilled
holes and secure with two button head bolts (f), see fig
07. Repeat on the process for the opposite side and carry
on for the remaining legs.
Fig 07
Fig 08-09
Step 5 Locate the three cross support brackets (4), line up
the pre-drilled holes in one of the brackets with the holes
in two of the angle brackets (6), using four button head
bolts (f) and nuts (b) secure the cross support bracket
(4) in position. Repeat for the remaining two side of the
assembly. (see figs 08-09).
Step 6 Locate the three castor wheels (22), screw each
castor into the threaded holes on top of legs (3), using a
spanner tighen the nut at the base of each castor to lock
the assembly in position. (see figs 10-11).
Fig 10-11
2
6
4
b
f
Step 7 Locate the extraction drum (7) and the 12unc
Hex screws (a). Position the drum on top of the motor
assembly (1), there are arrow marker labels on each unit,
line up these labels and secure the drum (7) to the motor
assembly (1) using the Hex screws (a). (see fig 12-13)
Fig 12-13
22
Locking Nut
Arrow marker label
a
Step 8 Loosen clamping bolt/nut from the extention
funnel (11), remove the clamping ring and place safely
aside. Lower the wide end of the funnel (11) on top of
the drum (7) and line up the rims. Locate the clamping
ring you removed earlier, position the ring over the
rims and tighten the bolt/nut to lock both units (7-11)
together. (see figs 14-15).
Continues Over...
7
1