Specifications

Assembly

Lift & shift handle pin lock

Turn butterfly knob to

lock the fence

Turning the handle to

lock pin

Fig 21

Fig 22

Fig 19

Fig 20

90˚ Stop

(a)

(b)

Spindle Guard Assembly

Step 3

Locate the spindle guard (D1) and the two M8 x 140mm lift & shift handles with washers (D2). Raise the spindle

to the maximum height by unlocking the spindle moulder rise/fall locking handle (a) and turning the spindle

moulder rise/fall wheel clockwise (b) then lock in place (See figs 23-24).

Remove the circular rings from the work table and place aside, see fig 25, Lower the spindle guard (D1) onto the

work surface & line up the machined slots in the guard casting (D1) with the two pre-drilled holes on either side

of the spindle (See figs 24-26). Put to hand the lift & shift handles (D2), slide each one through the machined slot

in the guard casting (D1) and screw them into the pre-drilled holes on the spindle table, locking the guard (D1) in

position (See figs 27-28).

Fig 23

Fig 24

(a)

(b)

Pre-drilled holes