Specifications

Assembly

Mi tre Fence Work Clamp Assembly

Step 5

Fig 35

Fig 36

Fig 37

Fig 38

Fig 39

Fig 40

Locate the pre-drilled metal plate (F3) & slot it into the machined ‘T’ slot in the sliding table (See figs 35-36).

Lower the mitre fence casting (F1) on top of the metal plate (F3), line up the machined slot & pre-drilled hole in

the mitre fence casting with the holes in the metal plate, see fig 37, locate the M10 clamping knob (F4) with

washer & screw it through the hole in the casting into the metal plate (F3) (See fig 38). Locate the lift and shift

handle (F5) and screw it through the machined slot into the remaining pre-drilled hole and lightly tighten (See

fig 39). Lastly locate the work clamp (F2) and slide it onto the steel rod, clamp in place by tightening the clamping

knob (See fig 40). (DO NOT OVERTIGHTEN)

‘T’ Slot