Specifications

Changing the Spindle Moulder Speed

Fig 68

Fig 69

Fig 70

Fig 71

Open the motor access door to the front of the machine, by removing the two caphead screws, see figs 68 & 69,

lower the spindle to it’s lowest point, if not done so already. Locate the 10mm allen key (G), loosen the caphead

bolt (H) on top of the motor, pull the motor tension lever (I) out, to allow the belt to go slack & reposition the belt

on the pulleys as required. When you are happy push back the tension lever (I) and tighten the caphead bolt (H)

to keep the tension (See figs 70,71 & 72).

Close the access door, raise the spindle,

reconnect the machine to the mains supply.

Give the machine a 'quick' burst check ( i.e.

quick ON-OFF) to ensure everything is O.K. If

everything is satisfactory, continue to use the

machine.

Fig 72

Caphead screw

Motor access door

DISCONNECT THE MACHINE FROM THE MAINS SUPPLY!