User manual

221
11.5 Printing P0 and P1 sweeps is not necessary for Evoked
RepeatSweep stimulation
Even though P0 and P1 sweep stimulation can be crucial to understanding experimental protocol flow
(such as during Fast Repeat Sweep LTD stimulation), P0 and P1 checkboxes need not necessarily be
checked to obtain the information. For example, if Fast Repeat Sweep LTD stimulation is evoked by
clicking on the ‘Repeat Sweep’ button, the first LTD sweep will be marked, and the first sweep after the
LTD stimulation will also be marked.
Fig 11.5.1a shows the simple protocol run outputting 20 P0sweeps at 5 sec periods.
MainProtocol
 Loop [ 20]
 P0sweep [ 5]s
EndLoop
EndProtocol
Fig. 11.5.1a.
However, after the 10
th
P0sweep, an ersatz Fast Repeat LTD stimulation of five P1sweeps every 1 sec
was manually evoked by clicking the ‘P1’ RepeatSweep button. The output of this protocol is shown in
Fig. 11.5.1b. Both the P0 and P1 checkboxes were checked. Sweep 06220162.P0 at 45.5 sec was the
last P0sweep before the Evoked FastRepeat stimulation, sweep 06220163.P1 at 50.5 sec is the first
Evoked FastRepeat stimulation, sweep 06220167.P1 at 54.5 sec is the last Evoked FastRepeat, and
sweep 06220168.P0 at 55.5 sec is the first post-FastRepeat sweep.