User manual

230
18:28:30.6 0.0 Start MainProtocol
18:28:31.1 0.5 Enter Loop0
18:28:31.1 0.5 09200243.P0, First Loop sweep
""
18:28:42.8 "" Stimulation Protocol Values
"" "" Continuous Acquisition - Used
"" "" MainProtocol tab
"" "" Start with MainProtocol
"" "" [x] Continuous Acquisition
"" "" Protocol Script Area
"" "" MainProtocol
"" "" [X] Loop [ 6]
"" "" [X] P0sweep [ 5]s
"" "" EndLoop
"" "" EndProtocol
"" "" Enable Sweep Functions
"" "" Pulse Train
"" "" [ ] [ ] Stimulus Artifact Blanking
"" "" [ ] [ ] Low-Pass Filtering
"" "" Evoked Events tab
"" "" Single Pulse or Train Sweep
"" "" [x] P0sweep
"" "" [ ] P1sweep
"" "" [ ] T0sweep
"" "" [ ] T1sweep NumSwps Add
"" "" Fast Repeat Pulse Sweeps (LTD) Avg toAvg Delay
"" "" [ ] P0 [ 30]*[ 2]s=1m [ ] [ ] [ ]
"" "" [ ] P1 [ 30]*[ 2]s=1m [ ] [ ] [ ]
"" "" Fast Repeat Train Sweeps (Theta) AddDelay
"" "" [ ] T0 [ 4]*[ 5]s=20s [ ]
"" "" [ ] T1 [ 4]*[ 5]s=20s [ ]
"" "" Sweep Stimulation Values
"" "" P0sweep tab
"" "" Sweep Duration = 100 msec
"" "" S0 tab Delay0 Pulse1 Off2
"" "" Pulse Dur (ms) 0.1
"" "" Pulse Interval (ms) 20 50
"" "" Number Pulses 1
"" "" S1 - NotUsed
"" "" IC0 - NotUsed
"" "" IC1 - NotUsed
"" "" P1sweep - NotUsed
"" "" T0sweep - NotUsed
"" "" T1sweep – NotUsed
18:28:46.1 15.5 09200246.P0, First sweep after Protocol values printed
18:29:01.1 30.5 Leave Loop0
18:29:01.1 30.5 Stop MainProtocol
Fig. 11.10.2. Stimulation values (in green) printed to the Experimental log when the ‘Stimulation’ button is
clicked, followed by the first sweep after the Stimulation protocol values are printed (purple). The Protocol
Builder script lines are shown in dark green.
Fig. 11.10.3 shows All Protocol Values printed when the ‘All’ button below the Experimental Log is clicked.
The information includes values in the Edit Protocol dialog box (except the Resources tabsheet) (first
yellow section), the Stimulation Protocol values (including values in the Plot/Save tabsheet) (green
section), the Experimental Log values (second yellow section), the Detection values (blue section), and all
other appropriate Dialog Box values (third yellow section).