User's Manual

Axon Fleet 2 Wireless Microphone Installation and User Manual
Axon Enterprise, Inc. Page 19 of 23
Connecting the Junction Box
The junction box connects in series between the Axon Fleet Power Unit and the Axon Fleet 2 front
camera. The power unit to camera cable is connected to the junction box, instead of the front camera,
and then the junction box cable is connected to the front camera.
1. Connect the power unit to camera cable to the junction box.
2. Connect the junction box cable to the front camera.
Installing the In-Car Charging Dock
There are three options for installing the in-car charging dock: on a flat surface using VHB tape, on the
partition between the front and rear seats, or on a carpeted area with sheet metal backing.
Attaching with VHB Tape
VHB tape is attached to the back of the in-car charging dock mounting flange and can be used to mount
the dock to a flat, rigid surface such as metal or plastic.
1. Prepare the mounting location by cleaning the surface with an alcohol wipe and allow the surface to
dry.
2. Peel the protective layer from the VHB tape and place the dock on the prepared location.
3. Push and hold the dock against the surface for 10 to 20 seconds to ensure adhesion.
4. Connect power to the in-car charging dock.
Attaching to the Partition
To mount the in-car charging dock on a partition, you drill holes into the partition and use the four round-
head screws and nuts, included in the installation kit.
Tools required for this installation:
• Drill with a No. 16 (.1770”) drill bit
• No. 2 Phillips driver
• 5/16” wrench.
1. Mark the location of the in-car charging dock mounting holes on the partition.
2. Drill the mounting holes using a #16 (.1770”) drill.
3. Use the four round-head screws and 5/16” nuts, provided in the installation kit, to attach the dock to
the partition.