User's Manual

Axon Fleet 2 Wireless Microphone Installation and User Manual
Axon Enterprise, Inc. Page 23 of 23
This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the
following two conditions: 1) this device may not cause interference, and 2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme aux normes d’exemption de licence RSS d’Industrie Canada. Son utilisation est
soumise aux conditions suivantes : 1) cet appareil ne doit pas causer de brouillage, et 2) doit accepter tout
brouillage, y compris le brouillage pouvant entraîner un fonctionnement indésirable.
Section 8.3 of RSS-GEN
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be chosen so that the equivalent
isotropically radiated power (e.i.r.p.) is not greater than necessary for successful communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio ne peut fonctionner
qu’au moyen d’une antenne d’un seul type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur
par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique pour les autres
utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas celle requise pour établir une communication satisfaisante.
Section 6.8 of RSS-GEN
These radio transmitters IC: 8803A-S01165 and IC: 8803A-S01166 have been approved by Innovation,
Science and Economic Development Canada to operate with the antenna type listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than
the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Axon Fleet 2 wireless microphone uses a (TBD) antenna. Antenna gain is <(TBD)dBi. The required
impedance for this antenna is (TBD) ohms.
Axon Fleet 2 junction box uses a (TBD) antenna. Antenna gain is <(TBD)dBi. The required impedance for
this antenna is (TBD) ohms.
Compliance Marks
Country of Origin: USA