Quick Setup Guide

Quick Setup Guide Hybrid

ILLUMINATE THE NIGHT
801 West Robinson Drive, Suite 500, North Salt Lake, UT 84054
q801/519-0500
< 801/519-0501
%
[e-mail]
Made in the USA
Lifetime Warranty

AXTON Illuminators have been designed and tested to run 24/7
continuously both indoors and outdoors.
You will need to log into the camera via computer and program
the I/O ports to trigger when IR illumination is desired.
To switch illuminator Infrared ON, your camera Output port(s)
have to be set as ACTIVE LOW. Status should be set to change
in association with/during an event like IR cut filter, motion
detection, etc.
To switch illuminator White Light ON, you will need a camera
with a second output or an external triggering device such as a
motion detector, door contact, etc. which will need to be set up
the same as above (ACTIVE LOW).
Below are some examples of devices that can be used to trigger
the illuminator's white light to switch ON during an event.

WIRING
Illuminator Ground Must Be Connected
to Cameras Digital Ground-Wiring
PROGRAM YOUR CAMERA
Common Trigger Devices
QUESTIONS ? [phone] or [e-mail] │axtontech.com
ILLUMINATE THE NIGHT
1.
Applying voltage other than the required range may
cause permanent damage and VOID WARRANTY.
Voltage Input
Polarity NON-Sensitive
24 V AC/DC
1.
Camera Door Contact Window SensorMotion Detector
TO / FROM ILLUMINATOR
WHITE
BLACK
BROWN
YELLOW
GREEN
BLUE
Digital GND
To Trigger
Device
To Trigger
Device
Power Input
IN/Infrared
IN/ White Light
OUT
Digital GND
TO/ FROM CAMERA
Apply Power
WARNING! Infrared light is not visible.
Do not view directly with optical instruments (magnifiers)
or stare directly into the illuminator at close distance.
Do not attempt to open or modify the light as this will void the
warranty. If you need a modification, electric or physical, contact us
directly. We will let you know if it can be done. All changes MUST be
made at our factory.
Make all electrical connections
BEFORE applying power.
TTTTTTT
