Quick Setup Guide

Quick Setup Guide Nano IR

ILLUMINATE THE NIGHT
801 West Robinson Drive, Suite 500, North Salt Lake, UT 84054
q801/519-0500 < 801/519-0501
%
[e-mail]
Made in the USA
Lifetime Warranty
RoHS

AXTON Illuminators have been designed and tested to run 24/7
continuously both indoors and outdoors.
Illuminator will trigger ON/OFF using the built in ambient light sensor
which has been pre-set to a threshold of 5-15 lux. ON will trigger
immediately while OFF will trigger after a 12-18 second delay.
You will need to log into the camera via computer and program the I/O ports to trigger when IR illumination is desired.

WIRING
OPTION 1 Constant ON
OPTION 2 Automatic
OPTION 3 External Controller (e.g. Camera)
QUESTIONS ? [phone] or [e-mail] │ www.axtontech.com
Make all electrical connections
BEFORE applying power.
TTTTTTT

ILLUMINATE THE NIGHT
AT-3M-S, AT-5M-S
Applying voltage other than the required range may
cause permanent damage and VOID WARRANTY.
VOLTAGE INPUT
Polarity Sensitive
12-18 Volts DC
TO / FROM ILLUMINATOR
ORANGE
GREEN
WHITE/BLUE
Power In Positive +
Power In Negative –
IN
WHITE/BROWN Day/Night
BROWN OUT
BLUE Digital GND
Apply Power
Jumper
TO / FROM ILLUMINATOR
ORANGE
GREEN
WHITE/BLUE
Power In Positive +
Power In Negative –
IN
WHITE/BROWN Day/Night
BROWN OUT
BLUE Digital GND
Apply Power
Jumpers
TO/ FROM CAMERA
To switch illuminator ON, your camera output port(s)
have to be ACTIVE and set to LOW (GND-ground).
You may associate this action with various events
(IR cut filter, motion detection, etc.) available on
your camera or external device.
TO / FROM ILLUMINATOR
ORANGE
GREEN
WHITE/BLUE
Power In Positive +
Power In Negative –
IN
WHITE/BROWN Day/Night
BROWN OUT
BLUE Digital GND
Apply
Power
WARNING! Infrared light is not visible. Do not view directly with optical
instruments (magnifiers) or stare directly into the illuminator at close distance
Do not attempt to open or modify the light as this will void the warranty.
If you need a modification, electric or physical, contact us directly. We will let
you know if it can be done. All changes MUST be made at our factory.