User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
5.1.2 nat
nat add device
device
{atm0 |atm1 | eth0} Corresponds to the device in the device
line that you want NAT enabled on. NAT should be enabled on the
WAN interface.
Example
The following example shows NAT enabled on the atm1 device.
nat add atm1
5.1.3 subnet
subnet add device
. networkID subnetmask
device
{atm0.home | atm1.home | eth0.home | bridge.home} Is used
to define what device the subnet is being defined for.
networkID
{a.b.c.d} The neworkID, which is defined in a decimal
format.
subnetmask
{ff:ff:ff:ff} The subnet mask in hexadecimal.
Example
The following example shows a subnet defined for the device that was defined in x.
NOTE: There is a period before the networkID, this is part of the
syntax and needs to be included.
subnet add atm0.home . 192.168.2.32 ff:ff:ff:e0
5.1.4 rip accept
rip accept interface version
interface
{device | all} This will correspond to the device defined on
the device line.
version
{1 | 2 | 1 2 | none} Defines which version of RIP you want to
accept.
Example
The following example shows the Ethernet interface accepting RIP version 1 & 2.
March 10, 2003 Company Confidential Page 17 of 149