User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
rip accept eth0 1 2
5.1.5 rip send
rip send interface version
interface
{device | all} This will correspond to the device defined in
device line.
version
{1 | 2 | 1 2 | none} Defines which version of RIP you want to
accept.
Example
The following example shows the wireless ATM interface sending RIP version 2.
rip send atm1 2
5.1.6 rip relay
rip relay version remoteip device timeout
version
{1 | 2 | 1 2} Version of RIP to send.
remoteip
{a.b.c.d} Remote IP address to send RIP to.
device
{device} Device that RIP is to be sent from. This will usually
be atm1 or atm0.
timeout
{seconds} The number of seconds until connection will
timeout. This parameter is optional, if not set the rip relay will not
timeout.
Example
The following example shows rip version 2 being sent over the wireless interface.
rip relay 2 192.168.10.3 atm1
5.1.7 route add
route add name network gateway netmask cost
name
Unique name used to identify the route.
network
{a.b.c.d} Network ID of remote network.
March 10, 2003 Company Confidential Page 18 of 149