User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
gateway
{a.b.c.d} Target IP address for path to remote network.
netmask
{ff:ff:ff:ff} Subnet mask of remote network.
cost
{#} Hop count to destination network, also referred to as
metric. Cost is optional, and will be set to 1 if nothing is set. If this is
not set correctly and you are running RIP it could overwrite the static
route.
Example
The following example shows a default route. A # sign can be used to put comments after
the route. In the example it is used to state that it is a manual route.
route add default 0.0.0.0 192.168.2.1 00:00:00:00 1 # MAN
5.1.8 ipatm lifetime
ipatm lifetime seconds
seconds
{?-?} The number of seconds an ATM cells can traverse a
network before it will timeout, like the TTL of an Ethernet frame.
Example
The following example shows the lifetime set to 60 seconds, which is the default.
ipatm lifetime 60
5.1.9 relay
relay interface
interface
{all} There are more options for this, but for the purpose of
keeping this simple just use “all”. Refer to the CLI document for
more options.
Example
The following example shows relay command being used to relay between all devices.
relay all
5.1.10 ipatm pvc add
ipatm pvc add interface port vpi/vci pcr pcr-rx/pcr-tx remoteip ipaddress
March 10, 2003 Company Confidential Page 19 of 149