User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
interface
{atm1 | atm0} This defines which device you want to bind the
ipatm pvc to.
port {atm25m | atm25i}
atm25m = wireless port
atm25i = terrestrial port
vpi
{0-7} Currently only VPI 0 is supported on the wireless
interface. The terrestrial interface can use any in the range.
vci
{32-65535} Virtual Circuit Identifier
pcr-rx,
pcr-tx
{0-70000} Peak Cell Rate, used to define the maximum cells
arrival/transmission rat at/from the wireless interface (ATM cells per
second).
rx = data received from the wireless interface to be sent over
the terrestrial interface.
tx = data received from the terrestrial interface to be sent over
the wireless interface.
ipaddress
{a.b.c.d} The remote IP address of the other device.
Example
The following example is an ipatm pvc for the wireless interface bound to the device
atm1. It is using VPI 0 & VCI 768 with a peak cell rate of 60000 and a destination IP address of
192.168.10.3.
ipatm pvc atm1 atm25i 0/768 pcr 70000/70000 remoteip 192.168.10.3
Old syntax
Note: The following old syntaxes are no longer valid.
ipatm pvc atm1 atm25i 0/768 pcr 60000 remoteip 192.168.10.3
ipatm pvc atm1 768/192.168.10.3/60000 atm25i
March 10, 2003 Company Confidential Page 20 of 149