User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
5.2.7 duplex
duplex type
type
{half | full} Sets the Ethernet interface to half or full duplex.
Example
The following example shows a unit’s interface set to full duplex.
duplex full
NOTE: If set to full duplex unit must be connected to a switch or router and
not a hub. The unit will not auto-negotiate in full duplex, so you must set switch
to 10Mb Full Duplex.
5.2.8 backoff
backoff dB
dB
{0-20} Reduces the transmit power and is measured in dB.
Backoff should only be used indoors or in rare situations that call for
less power to be transmitted from the antenna. Backoff should also
be set the same on all units in the sector.
Example
The following example shows a unit that is not backed off. This is how most of units in
the field will be configured.
backoff 0
5.2.9 provider
provider text
text
Text field that can hold up to 24 characters.
Example
The following example shows the Provider as “abw”.
provider abw
5.2.10 key
key code
March 10, 2003 Company Confidential Page 23 of 149