User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
pcr
{0-70000} Peak Cell Rate, used to define the maximum cells
arrival/transmission rat at/from the wireless interface (ATM cells per
second).
Example
TP (traffic parameter) sets the type of service that is desired and peak cell rate. The
following example show the TP default set to Unspecified Bit Rate with a Peak Cell Rate of
2667.
tp default UBR 2667
NOTE: When setting PCR for a bi-directional PVC the following applies.
atm25i – atm25m = terrestrial – wireless : which is the same as the tx in the ipatm pvc settings.
atm25m – atm25i = wireless – terrestrial : which is the same as the rx in the ipatm pvc settings.
5.3.2 sp
sp name buffer stats
name
{name | default} Can be assigned a name or the default.
buffer
{cells} Number of cells that can be buffered.
stats
{stats} Is optional, but needs to be used for the stats
command to work.
Example
SP (switch parameter) sets the size of the buffer in the switchcli and whether or not stats
are recorded. The following shows the buffer set to 256 cells and stats recording enabled. This
should be the default for all configs using the switchcli.
sp default 256 stats
N
5.3.3 add
add iport ivpi ivci oport ovpi ovci tp sp type epd
March 10, 2003 Company Confidential Page 26 of 149