User's Manual
Table Of Contents
- Revision History
- PLEASE READ THESE SAFETY PRECAUTIONS!
- Document Overview
- AB-Access Overview
- AB-Access Reference Model
- Static Configurations
- CLIP_T
- CLIP_S
- Hybrid CLIP_S
- 1483_T
- 1483_S
- Native ATM
- Extender
- RF Design and Planning
- SNMP
- Rupee
- RTFD (Return To Factory Default)
U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
6.1.2 Troubleshooting
6.1.2.1 AP Object
If the AP will not register make sure all the fields in the EMS database are correctly filled
in. Here are a few important points that should be kept in mind if the AP doesn’t register.
1. See if you can ping the unit. The default configuration is to have the AP receive a
DHCP address from the CS. If it has not received it you will not be able to ping it. So if you are
unable to ping the AP you should check and see that the dhcpd.conf file is setup properly. Notice
that in the example AP1 has a fixed address set, each AP must be given the same address every
March 10, 2003 Company Confidential Page 35 of 149