User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
1. Make sure the MAC address is correct. Without the correct MAC address the AP
can not register. You can verify what MAC address the AP is attempting to register with by
tailing the adapcs.log file. In the following example an AP is trying to register and is not found in
the database, which means when you created the object it had the wrong MAC address.
[root@cs1 /root]# tail -f /var/log/adapcs.log
CS[5025.8192](16Dec 12:36:03.027 ): AtmAccessPointImpl: Unknown ATM AP 00c0690c522f trying to register
2. The management address must be on the same subnet as the atm0 interface on the
Control Server.
3. Check that the PVCs are mapped correctly in the switch. Since the problem is
with the AP registering, pay close attention to how the registration PVC (61) and management
PVC are mapped.
ADMIN Access_NGI>show pvc list id 0
ADMIN Access_NGI>
----------------------------------------------------------------------------
PVC ID IPort IVPI IVCI BW OPort OVPI OVCI BW
----------------------------------------------------------------------------
1 101 0 32 0 102 0 61 0
2 101 0 33 0 102 0 33 0
4. The “AS Port” has to be filled in with the proper port if you have chosen to
manage the anchor switch with the EMS (selected when creating the Control Server).
5. Make sure the Control Server has the created the proper atmarp entries in it. There
should be an atmarp entry for every management address.
• Lists atmarp entries
[root@cs1 /root]# atmarp -a
----- Itf 0 (192.168.2.1, netmask 255.255.255.0) -----
Default QOS: ubr,aal5:max_sdu=9188
IP 192.168.2.50, state VALID, addr <none>, flags 0x4<PERM> 0.0.33
----- Unknown incoming connections -----
----- Incoming unidirectional connections -----
----- End of dump -----
7.1.2.2 SU Object
If the SU will not register make sure all the fields in the EMS database are filled in
properly. Here are a few important points that should be kept in mind if the SU doesn’t register.
Many different things can cause the SU not to register so after verifying all of these points and it
still doesn’t register the next step will be to troubleshoot the RF link. See RF troubleshooting
document.
March 10, 2003 Company Confidential Page 57 of 149