User's Manual

Table Of Contents

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless

• Delete a PVC

ADMIN Access_NGI>set pvc del 1

1. Check all physical connections. The radio is a network device, which means if

you connect it to a PC (NIC) you will use a straight cable. If you connect the radio to a network

device (hub, switch, router) you will use a Ethernet cross-over cable(1-3, 2-6). It is also

important to check that the cable is punched down correctly in the wall box and the cable is

terminated correctly at the radio. The termination at the radio uses 568B

(wo,o,wg,bl,wbl,g,wbr,br).

2. Make sure the computer you are pinging from is on the same network as the AP.

If you are on a different network than the radio make sure you have the proper routes in the radio

and the computer you are trying to ping from.

7.2.4.2 Can’t ping across the wireless link

There are numerous reason why you couldn’t ping across the wireless link. After

following these troubleshooting steps and you still can’t ping across the wireless link refer to the

RF troubleshooting document.

1. Check that SU has the proper MID.

192.168.3.10 hmm> system mid

MID 3

2. Check the ipatm pvc is correct in relation to the MID and remoteip

192.168.2.50 ip> ipatm pvc

ipatm pvc atm1 atm25m 0/768 pcr 70000/70000 remoteip 192.168.100.3

192.168.3.65 ip> ipatm pvc

ipatm pvc atm1 atm25m 0/768 pcr 70000/70000 remoteip 192.168.100.1

3. Check the default route in the SU.

192.168.3.65 ip> route

route add default 0.0.0.0 192.168.100.1 00:00:00:00 1 # MAN via atm1

March 10, 2003 Company Confidential Page 65 of 149