User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
9.2.2.2 SU initbridge
spanning disable
device add edd
device add r1483
9.2.2.3 SU system.conf
channel 0
antenna horizontal
mode static
mid 3
bid 0
interface eth0
backoff 0
provider abw
key Axxcelera
mask 1ffff
leds active
9.2.2.4 SU initr1483
pvc 0/768 atm25m 70000 70000
9.2.3 Troubleshooting
9.2.3.1 Can’t ping the radio from the terrestrial interface.
1. Check all physical connections. The radio is a network device, which means if
you connect it to a PC (NIC) you will use a straight cable. If you connect the radio to a network
device (hub, switch, router) you will use a Ethernet cross-over cable(1-3, 2-6). It is also
important to check that the cable is punched down correctly in the wall box and the cable is
terminated correctly at the radio. The termination at the radio uses 568B
(wo,o,wg,bl,wbl,g,wbr,br).
2. Make sure the computer you are pinging from is on the same network as the AP.
If you are on a different network than the radio make sure you have the proper routes in the radio
and the computer you are trying to ping from.
March 10, 2003 Company Confidential Page 89 of 149