Trouble Shooting Guide
Table Of Contents
- Troubleshooting-Installing an RF link
- Issue : 5.3.x
- Authors : Matt Olson/Dave Sida
- Date : 30th July 2004
- CONTENTS
- CHANGE HISTORY
- INTRODUCTION
- Aligning an SU
- Fine tuning an SU
- SU signal quality
- Troubleshooting SU link from AP
- Link status
- AP Link Status
- SU Link Status
- MAC type
- Unit MAC address
- Channel
- Radio Channel Mask
- Correlation sequence
- MAC delay compensation
- Unit Range
- Base Station ID
- Radio Temperature
- RSSI
- Path loss in excess of FSL (estimate)
- Downlink RSSI Fade Margin
- TX maximum backoff
- TX current backoff
- Max TX power for channel
- Actual TX power
- Averaging MAC error rates over
- Downlink Header Error Rate
- Downlink Cell Error Rate
- Uplink Cell Error Rate
- Modem RSSI
- Mac stats
- Modem txpower
- Modem mmse
- PNMS Sector
- Survey Scan
- Modem msreg 6 1
- Modem rxdc stats
- Bun list channels
Axxcelera Broadband
Troubleshooting-Installing an RF link - 8 - Issue: 5.3.x
Rev 2
2 INTRODUCTION
This document’s purpose is to help troubleshoot radio problems with the AB-Access and
AB-Extender products. This document should only be used with System Software 5.1.5
or above, because some of the CLI commands described here are either different or not
supported by earlier software revisions.