User's Manual
Table Of Contents
- 1.0 Preface
- 2.0 Introduction
- 3.0 Installation
- 3.1 Compliance Alert - Operation in the 3.4 - 3.6 GHz Band
- 3.2 Operation in the 3.650 - 3.675 GHz Band
- 3.3 Installation Warnings
- 3.4 Environmental Cautions
- 3.5 Installing Outdoor Equipment
- 3.6 Installing an Optional Sector Antenna
- 3.7 Installing Optional Omnidirectional Antenna
- 3.8 Installing the Access Point
- 3.9 Power and Data Connections - AC and DC Power Options
- 4.0 Configuring an Access Point for Single-Channel Use
- 5.0 Maintenance Guide
- Appendix A: NIA/Power Adapter Specifications: Model # TR60A-POE-L
- Appendix B: ExcelMax DC PSU/NIA (020-44109-0802)
- Appendix C: Glossary of Terms and Abbreviations
EXCELMAX ACCESS POINT CELL INSTALLATION AND MAINTENANCE GUIDE VERSION 1.4
16
OF 65
3.0 Installation
3.1 Compliance Alert – Operation in the 3.4 - 3.6 GHz Band
The CE Marking with alert symbol (see below) appears on the Access Point assembly. The alert
symbol indicates operation on frequency bands that are not harmonized throughout the European
community.
Figure 3-8: Compliance Alert Label
Member states must be notified, in accordance with Article 6.4 of the R&TTE Directive 99/5/EC,
before this equipment can be sold or put into service. Contact Axxcelera Customer Support for an
up-to-date listing of Member State Notifications. See “Technical Support” on page 8.
3.2 Operation in the 3.650 - 3.675 GHz Band
3.2.1 FCC Information to Users @ FCC 15.21 & 15.105
For Class B Unintentional Radiators:
This equipment has been tested and found to comply with the limits for a Class B digital devices,
p
ursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of more of the following
measures:
• Reorient or relocate the r
eceiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
con
nected.
• Consult the dealer or an experienced radio/TV technician for help.
3.2.2 Warning to Users @ FCC 15.21 & 15.105:
Note
This equipment operates in the 3.4 - 3.6 GHz frequency band, which is not
harmonized throughout the community.
Warning
Changes or modifications not expressly approved by Axxcelera Broadband
Wireless could void the user’s authority to operate the equipment
N