User's Manual

AxxceLTE eNodeB

Installation Guide v1.0 - 11 -

4 Mounting

The face of both the RRH and BBU casing have (4) mounting points for attachment to

the hanging brace. The AxxceLTE

eNodeB package includes all necessary mounting

bracket hardware to allow for wall or pole mounting the unit. Instructions for mounting

the eNodeB in either configuration are included with the mounting bracket. Please

follow all instructions provided with the mounting hardware.

Be certain to mount the eNodeB in the direction indicator markings on the case itself.

The connector panel must be on the bottom to minimize any potential water ingress to the

case. Failure to mount the eNodeB properly may result in serious damage to the unit.

Figure 4.1 shows the eNodeB mounted to a pole.

Figure 4.1 – eNodeB Pole Mounted

Using the same bracket hardware, the eNodeB can also be mounted to a wall. For wall

mounting, the rear-most part of the bracket and the threaded rods are not used, and the

eNodeB side of the bracket with the stabilizing bar is rotated and mounted to the wall.

Figure 4.2 shows the eNodeB mounted to a wall.