User's Manual

AxxceLTE eNodeB

Installation Guide v1.0 - 14 -

6 Basic Configuration

Following installation and power up, you are now ready to begin configuring your

eNodeB. This section will outline several basic configuration steps necessary to allow

you to connect to the device. For more detailed configuration information, please see the

AxxceLTE Application Console User Manual.

6.1 Setting the eNodeB IP Address

Once the eNodeB has been installed and power has been applied, you will need to set an

IP address on the device. As previously described, there are two components to the

eNodeB – the BBU and the RRH. Each component requires a unique IP address so it can

be properly managed following installation.

Base Band Unit

To perform a basic configuration of the BBU, use the AxxceLTE Application Console

software to access the device. The default IP address of a base band unit is

192.168.100.200. Change the IP address of the BBU via the Application Console. See

the User Guide for further configuration information.

Remote Radio Head

To perform a basic configuration of the RRH, point a web browser at the device’s default

IP address to access the web management GUI. The default IP address of a remote radio

head is 192.168.100.100

Point your browser at http://192.168.100.100 and enter the credentials:

Username: admin

Password: admin

This will allow you to access management features of the RRH. It is advised to only use

this interface for the purpose of setting the device IP address. Any detailed

configurations should be accomplished using the AxxceLTE Application Console

application.

6.2 Base Band Unit Panel LEDs

Included on the BBU are a set of LED Indicators. The figure below shows the layout of

these LEDs on the bottom panel of the BBU.