CD Receiver Installation & Owner's Manual 3 Band EQ HPF/LPF/Q-Factor/C-Freq. 2 USB Ports iPod®/iPhone®/Flash Drive HFP/A2DP/AVRCP/PBAP SDHC Supported XDMA7600 CD CD-R/RW Compatible Aux 3.
XDMA7600 Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit, • Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
XDMA7600 Wiring Diagram RCA Preamp Output Connections BLACK Female USB Input Rear USB Connection SUBWOOFER REAR FRONT FRONT REAR SUB/W L-CH R-CH REMOTE IN Antenna Connector Optional USB Extension Cable (Included) Steering Wheel Interface Input PAC SWI-PS connection (sold separately) 3.5mm BLUE BLACK RED YELLOW Bluetooth Microphone Input Connect the included Bluetooth microphone. Remote Turn-On Connect to amplifier or power antenna. Insulate wire if not used.
XDMA7600 Receiver - Controls 1 20 2 3 19 4 5 18 17 6 7 16 15 14 13 12 11 Control Function 1 Source/Power 2 Band/Back 3 Select Activates music searches. Confirms menu options. 4 Color Changes the illumination color. Hold to access the color menu. 5 Bluetooth Talk Accesses additional radio presets and cycles between FM and AM radio. Steps backward or exits music searches or menus. Answers phone calls. Accesses Number Dial, Recent Calls and Redial functions.
XDMA7600 IR Remote - Controls 1 2 3 4 5 21 6 20 7 19 8 18 9 17 10 16 11 15 12 14 13 1 Source / Power ( ) 12 Key 9 / # Key 2 Select 13 End Call 3 Volume Up 14 Key 0 / Display 4 Audio / Menu 15 Talk 5 Tune / Track Up 16 Key 7 / * Key 6 Volume Down 17 Key 8 / Color 7 Mute 18 Preset 4 / Play / Pause 8 Preset 2 / Random 19 Preset 1 / Repeat 9 Preset 3 / Intro 20 Band / Back 10 Preset 6 / Folder Up 21 Tune / Track Down 11 Preset 5 / Folder Down 5
XDMA7600 General Operation Faceplate Removal Power On/Off Source Press RELEASE to fold down the front panel. While pushing the front panel left, pull the right side away to remove. To reinstall, slide in bottom left side, then snap left side up and into place. Press or any other button to turn unit on. Press and hold turn unit off. to Press SOURCE to select between AM/FM, CD, auxiliary input, operation of iPod, USB, SD and Bluetooth modes. Modes of operation are indicated in the display.
XDMA7600 Setup Menu Press and hold AUDIO/MENU for more than 3 seconds to access the setup menu, then press AUDIO/MENU to cycle through menu options. When desired option appears in the display, rotate the volume knob left/right to adjust or activate desired function. Press BACK to exit any menu or submenu. Function Options Action Auto Station Store AUTO PGM STATIONS Press SELECT to begin automatically programming strong radio stations to the 6 preset buttons in the current band.
XDMA7600 Audio Menu Press AUDIO/MENU momentarily to cycle between Bass, Treble, Balance, Fader, Equalizer, Subwoofer, High Pass Filter and Source Volume Level. Press BACK at any time to exit the audio menu. BASS MIDDLE TREBLE BALANCE FADER EQ SUBWOOFER HPF SOURCE LEVEL Bass Press AUDIO/MENU until BASS appears, then rotate the volume knob left/right to adjust (-6 minimum / +6 maximum).
XDMA7600 Audio Menu - Advanced Control The XDMA7600 inclues advanced audio control to provide superior adjustability in the sound output. These adjustments include: • Center Frequency - focuses bass, mid, and treble adjustments around a specific frequency. • Quality ("Q") Factor - narrows or expands the bass or mid bandwidth around the center frequency. • Low Pass Filters - removes mid and treble frequencies from the subwoofer RCA outputs.
XDMA7600 LCD Icon Layout Stereo FM Reception Repeat Loudness Tuner Random Operation of iPod Aux SD Card USB Phone Call Bluetooth CD-in Artist Name File Name Song Title Album Name Folder Name AM/FM Tuner Operation Seek Tuning Manual Tuning nn ll for more than one second Press TUNE nn or TUNE ll momentarily to move radio frequency up or down one step at a time. Press and Press TUNE or TUNE to seek the next strong station. hold to advance quickly.
XDMA7600 CD Player Operation - Audio CDs Insert CD Fold down front panel to access the CD slot. With the label facing up, insert a standard size CD into the CD slot. The CD will automatically begin playback. Eject CD Fold down front panel and press EJECT to eject the CD. The unit will change to previous mode of operation. If the disc is not removed within 10 seconds, the unit will reload the disc. The unit does not have to be turned on to eject CD.
XDMA7600 CD Player Operation - MP3/WMA/AAC Playing an MP3/WMA/ AAC Disc Folder Access When an MP3/WMA/AAC encoded disc is first inserted, “READING” will appear in the display. Depending on the number of files and folders, this may take several seconds. Press Press to select the next folder. to select the previous folder. *Folder access is only available on discs recorded with more than one folder.
XDMA7600 CD Player Operation - MP3/WMA/AAC File/Folder Search Begin Searching Search menu controls Press SELECT to enter the data CD file/folder search mode. An alphabetical list of files and folders in the current folder from the USB/SD card device will be displayed. • Turn the volume knob to cycle through the list of files and folders. • Press SELECT to change to the selected folder or play the selected file.
XDMA7600 CD Player Operation - MP3/WMA/AAC File/Folder Compatibility and Support Compatible File Types Incompatible File Types Recording Format Compatibility Sampling Frequency Rate Compatibility Transfer Bit Rate Compatibility Character Support ID3 Tag Support File/Folder Limit • CD-ROM (ISO), CD-R, CD-RW • CD-DA (digital audio) • MP3 data (.mp3) • WMA data (.wma) • AAC data (.
XDMA7600 Operation of iPod/iPhone Connecting an iPod/iPhone Device USB Connection Using the "dock connector to USB" sync cable (provided with the iPod/iPhone device), plug the USB cable into one of the XDMA7600's two USB ports. Once connected, playback will begin automatically. You may connect the iPod/iPhone device to the front USB port, rear USB port, or to both ports. A USB extension cable is included for better rear USB port access.
XDMA7600 Operation of iPod/iPhone Controlling a Device: Full Control - Music Search The XDMA7600 features a powerful music search that simplifies the searching process. Follow the steps below to find the desired song: Begin Searching Select a Category Press SELECT to begin the search. The main search menu will appear. Turn the volume knob to select between artist, album, song, playlist, podcast, audiobook and genre. Press SELECT to select the desired search category.
XDMA7600 Operation of iPod/iPhone Controlling a Device: Manual Control When the control of iPod/iPhone feature is set to "MANUAL" in the iPod Menu, use the following functions to control the device: Manual Control for iPod When "MANUAL" control for iPod is selected from the Setup Menu, the iPod or iPhone device can be controlled directly from the device's interface. All functions except for volume can be used from the iPod or iPhone device.
XDMA7600 USB/SD Card Operation Connect a USB Device (sold separately) To play MP3/WMA/AAC files from most mass storage devices,connect a device to one of the XDMA7600's two USB ports (front or rear). Connect an SD Card (sold separately) To play MP3/WMA/AAC files from an SD Card, insert an SD card into the XDMA7600's SD card slot, located behind the front panel. Insert the SD card with the label facing to the left, and press the card until it clicks into place.
XDMA7600 USB/SD Card Operation File/Folder Search Begin Searching Search menu controls Press SELECT to enter the USB/SD file/folder search mode. An alphabetical list of files and folders in the current folder from the USB/SD card device will be displayed. • Turn the volume knob to cycle through the list of files and folders. • Press SELECT to change to the selected folder or play the selected file.
XDMA7600 USB / SD Card Operation Displayed Information Press DISP momentarily to select between song title/artist (default), file/folder name, track number/clock & elapsed time. (LINE 1) (LINE 2) ARTIST SONG TITLE FILE NAME FOLDER NAME ELAPSED TIME CLOCK TRACK NUMBER TOTAL TRACKS File/Folder Compatibility and Support • MP3 data (.mp3) • WMA data (.wma) • AAC data (.
XDMA7600 Bluetooth® Operation Pairing a Device Preparation Pairing a New Device Before you can use a Bluetooth device, it must be paired and connected. Make sure that Bluetooth is activated on your device before you begin the pairing process. The XDMA7600 broadcasts the pairing signal constantly when no devices are currently connected. Complete the pairing sequence from your Bluetooth device. Refer to the owner's manual for your device for more details.
XDMA7600 Bluetooth® Operation Making a Phone Call Manual Dialing • Press once. "Enter Number" will be shown, then an "_" will appear on the display. • Using the remote control, enter the phone number using the 0-9 buttons. Press on the remote control or XDMA7600 front panel to begin dialing. Note: Placing a phone call from your cell phone will also use the Bluetooth function of the XDMA7600.
XDMA7600 Bluetooth® Operation Receiving and Ending Phone Calls Receiving a Phone Call Incoming phone calls will automatically appear on the display and a ring tone will be heard. Note: The volume of the ring tone depends on the volume level of the XDMA7600. The incoming ring tone may not be heard if the volume is set to a low level or mute is activated. • Press • Press to receive the incoming phone call. to refuse the incoming phone call.
XDMA7600 Bluetooth® Operation Streaming Audio Operation The XDMA7600 supports A2DP (advanced audio distribution profile) wireless streaming audio from your Bluetooth mobile device directly to your head unit. You can also control your music from the front panel of the head unit using AVRCP (audio video remote control profile). Notes: • To stream music to your head unit, your mobile device must support the A2DP and AVRCP Bluetooth profiles. Check the owner's manual of your mobile device for details.
XDMA7600 Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp.
XDMA7600 Troubleshooting - General Problem Unit will not turn on (no power) Unit has power (but no sound) Unit blows fuses Excessive Skipping ERROR-01 appears on display ERROR-02 appears on display CD will not eject PROTECT appears on display Cause Action Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Black wire not connected Fuse blown Speaker wires not connected Check connections for proper voltage (11-16VDC) One or more speaker wires touching each othe
XDMA7600 Specifications FM Tuner Tuning range: 87.5MHz - 107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: 40dB Frequency response: 30Hz - 13kHz AM Tuner Tuning range: 530kHz - 1710kHz Usable sensitivity: 22uV Frequency response: 30Hz - 2.2kHz General Speaker output impedance: 4 to 8 ohms Line output voltage: 2 Volts RMS Dimensions: 7" x 7" x 2" (178 x 178 x 51 mm) USB/SD Card File system: FAT, FAT32 File extensions support: .mp3, .wma, .
XDMA7600 FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
XDMA7600 Notes 29
XDMA7600 Notes 30
XDMA7600 Notes 31
Dual Electronics Corp. Toll Free: 1-866-382-5476 axxera.dualav.com ©2011 Dual Electronics Corp. All rights reserved. iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone, respectively, and has been certified by the developer to meet Apple performance standards.
