Installation manual

11
Note: Not every radio will have all the possible SWC commands
on the steering wheel. Aftermarket radios that do not have Bluetooth
will not recognize the PTT (Push To Talk) or “On/Off Hook”
commands; however those buttons can be manually programmed
to do other commands in some cases. Please refer to the radio
owner’s manual or wireless remote for specific commands that the
radio will recognize.
1) Completeconnectionstothevehicleandtotheaftermarketradio,
makesurethe3.5mmconnectorisconnected.
IfthisisthefirsttimetheASWC-1isbeinginstalledinavehicle:
2) Turntheignitionon;theLEDwillstartflashingrapidly.
3) After10secondstheASWC-1willgointotheLEDfeedbackmode.
AftertheseriesofLEDflashestheLEDwillstayinaslowconstant
flashstate.Gotostep4.
--- Or ---
IftheASWC-1hasbeeninavehiclebefore:
2) Pressandholdtheresetbuttondownformorethen10seconds.
3) Afterthe10secondstheLEDwillbeginaslowconstantflash.
4) Atthispointpressandholdthe“VolumeUp”buttononthesteering
wheelfor7secondsuntiltheLEDgoessolidred.Nowreleasethe
“VolumeUp”buttonandtheLEDgoes“Off”.“VolumeUp”hasnow
beenprogrammed.
Section 3: Troubleshooting