Installation manual

6
Section 1: Installation
Onceyouhavecollectedorprintedouttheinformationsheetonyour
particularvehiclefromtheAxxesswebsite(www.axxessinterface.com)
you’rereadytoinstalltheASWC-1.
Installing the ASWC-1
1) ConnecttheBlackwireoftheASWC-1toground.Youmayusethe
samegroundingpointastheaftermarketradio.
2) ConnecttheRedwireoftheASWC-1toa12-voltaccessorywire, 
onethatturns“On”and“Off”withtheignitionkey.
3) LocatethecorrectSWCwire(s)inthevehicle’sradioprimaryor
secondaryharnessasdescribedinthevehicleinformationsheet
foundontheAxxesswebsite.Connectthecorrectwirecolor(s)from
theASWC-1tothesteeringwheelcontrolwire(s)inthevehicle.
Note: Metra recommends that the wire(s) are soldered for the
best and most secure connection. T-Taps or scotch locks are not
recommended due to the higher chance of an intermitted connection
or change in resistive values.