Installation manual

14
ASWC-1 Installation
Dual Assignment Instructions
Note: Seek Up and Seek Down are already set to Preset Up and
Preset Down for a long button press.
1) Turnontheignitionbutdonotstartthevehicle.
2) Pressandholddownthesteeringwheelbutton,thatyouwantto
assignalongpressfunction,forabout10secondsuntiltheLED
rapidlyflashesgreen.AtthispointreleasethebuttonandtheLED
willgosolidgreen.
3) Pressandreleasethe Volume Upbuttonthenumberoftimes
correspondingtothenewbuttonnumberselected(refertothechart
onp.15).ThegreenLEDwillblinkrapidlywhentheVolume Upis
pressedandbacktosolidgreenwhenreleased.Thengotothenext
stepwhentheVolume Upbuttonhasbeenpressedthedesired
numberoftimes.
Caution: If more than 10 seconds elapses between a Volume Up
button press this procedure will abort, and the LED will go off.
4) Tostorethelongpressbuttoninmemory,pressthebuttonthatyou
assignedalongpressbutton(thebuttonhelddowninStep1).The
LEDwillnowgooffindicatingithasbeenstored.
Note: These steps must be repeated for each button you would like to
assign dual purpose action to.
Toresetabutton,backtoitsoriginaluse,repeatStep1.Thenpressthe
Volume Downbutton.TheLEDwillgooffandthelongpressmapping
for thebuttonwillbeerased.