Installation manual

7
ASWC-1 Installation
Connections to be made
B. For Metra OE radios:Connectthesteeringwheelcontrol
Key1wire(Gray)totheBrownwireoftheASWC-1.Isolateand
tapetheBrown/Whitewire,itwillnotbeused.
C. For Kenwood, or select JVC’s with a Blue/Yellow steering
wheel control wire:ConnecttheKenwood/JVCsteeringwheel
controlwiretotheBrownwireoftheASWC-1.Isolateandtape
theBrown/Whitewire,itwillnotbeused.
Note: Some of the newer Kenwood radios will auto detect as
a JVC. If this is the case, (a) use the included 12k ohm resistor
in-line between the Blue/Yellow and Brown wire of the female
3.5mm jack only during programming (remove resistor once
programmed) or (b) you can manually set the radio type, refer to
the Changing Radio Type section (pp. 12-13).
D. For XITE radios:ConnectthesteeringwheelcontrolSWC-2wire
fromtheradiototheBrownwireoftheASWC-1.Isolateandtape
theBrown/Whitewire,itwillnotbeused.
2) For Parrot Asteroid Smart or Tablets:Connectthe3.5mmjackof
theASWC-1intothefemale3.5mmjackoftheAX-SWC-PARROT
(soldseparately).Thenplugthe4-pinmaleharnessintothe
correspondingsteeringwheelcontrolfemaleharnessintheradio.
Note: AX-SWC-PARROT is required (sold separately) and the radio
must be updated to rev. 2.1.4 or higher. Additionally, the ASWC-1
must be updated to the most recent software available.
3) For all other radios:Pluginthemale3.5mmconnectorofthe
ASWC-1intothebackoftheaftermarketradio,designatedfor
anexternalsteeringwheelcontrolinterface.Pleaserefertothe
aftermarketradiosmanualifindoubtwherethe3.5mmconnector
oftheASWC-1goesinto.