Installation manual

9
4) AfterafewsecondstheLEDshouldstopflashingrapidlyandgoout
forapproximately2seconds.Atthispointdonotpressanybuttons.
5) Aftertheapproximate2secondstherewillbeaseriesof7Green
flashes,someshort, andsomelong.Thelongflashesrepresentthe
wiresthat
arere cognizedbytheASWC-1.
Tip: Knowing this will help if you need to troubleshoot; refer to p. 22,
for the appropriate LED Feedback section legend.
6) TheLEDwillpauseforanother2seconds,andthenflashRedupto
15timesd
epend ingonwhatradioisconnectedtotheASWC-1.
Tip: Knowing this will help if you need to troubleshoot; refer to p. 23,
for the appropriate LED Feedback section legend.
7) Thisistheendoftheautodetectionstage.IftheASWC-1detected
thevehicleandtheradiosuccessfullytheLEDwilllightupsolid.
8) ForvehicleswithOEBluetoothbuttons,pressandholdthe
Hang uporPick upbuttononthesteeringwheelaftertheLEDon
theASWC-1goessolid.IftheOEBluetoothbuttonsareabletobe
usedtheLEDwillgooutafter3seconds.YourOEBluetoothbuttons
arenowprogrammedtoyourafterm
arketra dio.
Note: The aftermarket radio must have Bluetooth capability and must
be able to accept these commands.
9) Makesurethesteeringwheelcontrolbuttonsfunctioncorrectlyinthe
vehicleandenjoy.
Tip: If the ASWC-1 did not go to a solid LED, press the Reset button
for 3 seconds, release, and then start from Step 3. If the LED still doesn’t
go to a solid LED refer to the LED Feedback section (p. 22).This will help
you to determine if the ASWC-1 is detecting your vehicle. If not, refer to
the instructions starting on p. 6, and make sure all the instructions were
followed as stated. If you have done this and the ASWC-1 is still not going
to a solid LED please refer to the Troubleshooting section (pp. 16-18).
ASWC-1 Installation
Programming