Installation manual

Note: Not every radio will have all the possible SWC commands on
the steering wheel. Aftermarket radios that do not have Bluetooth
will not recognize the PTT (Push To Talk) or “On/”off” Hook”
commands; however those buttons can be manually programmed to
do other commands in some cases. Please refer to the radio owner’s
manual or wireless remote for specific commands that the radio will
recognize.
1) Completeconnectionstothevehicleandtotheaftermarketradio,
makesurethe3.5mmconnectorisconnected.
IfthisisthefirsttimetheASWCisbeinginstalledinavehicle:
2) Turntheignitionon;theLEDwillstartflashingrapidly.
3) After10secondstheASWCwillgointotheLEDfeedbackmode.
AftertheseriesofLEDflashestheLEDwillstayinaslowconstant
flashstate.Gotostep4.
--- Or ---
IftheASWChasbeeninavehiclebefore:
2) Pressandholdtheresetbuttondownformorethen10seconds.
3) Afterthe10secondstheLEDwillbeginaslowconstantflash.
4) Atthispointpressandholdthe“VolumeUp”buttononthesteering
wheelfor7secondsuntiltheLEDgoessolidred.Nowreleasethe
“VolumeUp”buttonandtheLEDgoes“off”.“VolumeUp”hasnow
beenprogrammed.
Section 3: Troubleshooting