User Manual

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certiﬁed technicians

IMPORTANT

If you are having difﬁculties with the installation of this product,

please call our Tech Support line at 1-800-253-TECH. Before doing

so, look over the instructions a second time, and make sure the

installation was performed exactly as the instructions are stated.

Please have the vehicle apart and ready to perform troubleshooting

steps before calling.

INSTALLATION INSTRUCTIONS

AX-ADBOX2

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connect the (1) Red wire to the accessory wire.

• Connect the Orange/White wire to the illumination wire. If the aftermarket radio does not have an illumination wire, tape off

the Orange/White wire.

• Connect the Blue/White wire to the amp turn on wire (this wire must be connected to hear sound from the factory ampliﬁer).

• Connect the Brown wire to the mute wire. If the aftermarket radio does not have a Mute wire, tape up the Brown wire.

For aftermarket radios with navigation built-in

• Connect the Light Green wire to the parking brake wire

• Connect the Blue/Pink wire to the V.S.S. or speed sense wire

• Connect the Green/Purple wire to the reverse wire.

Note:

For the remaining wires, please refer to the instructions supplied with the required wiring harness.

CONNECTIONS TO BE MADE