User Manual

ManualsBrandsAXXESS ManualsCar Electronics & GPSAXXESS - Car Audio Replacement Interface for Select Mercedes Vehicles - Black

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

AX-MC90082

INSTALLATION INSTRUCTIONS

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell

caps, etc.)

TABLE OF CONTENTS

Connections to be made .......................................2

Installing the AX-MC90082 interface ....................3

Programming the ASWC-1 interface .....................3

Mercedes ML (W164) (with M.O.S.T. 25 ampliﬁer) Data Interface with SWC 2005-2011

Mercedes GL (X164) (with M.O.S.T. 25 ampliﬁer) Data Interface with SWC 2006-2010

• Provides accessory power

• Retains R.A.P. (retained accessory power)

• Designed for ampliﬁed models

• Provides NAV outputs (parking brake, reverse, speed sense)

• Retains audio controls on the steering wheel

• Retains balance

• Micro “B” USB updatable

• AX-MC90082 interface

• AX-MC90082 ampliﬁer interface

• ASWC-1 interface

• AX-MC90082 harness

• ASWC-1 harness

• Female 3.5mm connector with stripped leads

Summary of content (4 pages)

PAGE 1
AX-MC90082 I N S TA L L AT I O N I N S T R U C T I O N S Mercedes ML (W164) (with M.O.S.T. 25 amplifier) Data Interface with SWC 2005-2011 Mercedes GL (X164) (with M.O.S.T. 25 amplifier) Data Interface with SWC 2006-2010 INTERFACE FEATURES • Provides accessory power • Retains R.A.P.
PAGE 2
CONNECTIONS TO BE MADE From the aftermarket radio to the AX-MC90082 harness: • Connect the Black wire to the ground wire. • For the radios listed below, connect the female 3.5mm connector with stripped leads, to the male 3.5mm SWC jack from the ASWC-1 harness. Any remaining wires tape off and disregard: • Connect the Red wire to the accessory wire. • Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/ White wire of the connector.
PAGE 3
INSTALLING THE AX-MC90082 INTERFACE With the key in the off position: • Connect the AX-MC90082 harness to the AX-MC90082 interface. • Connect the AX-MC90082 harness to the AX-MC90082 amplifier interface. • Remove the dust cover from fiber optic port in the AX-MC90082 amplifier interface. • Connect the factory fiber optic cable into the AX-MC90082 amplifier interface. • Connect the AX-MC90082 harness to the wiring harness in the vehicle.
PAGE 4
AX-MC90082 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.