Other Content

TYTO-01
3
Connections to be made
From the 20-pin harness,totheaftermarketradio:
• ConnecttheYellowwiretothe12-voltbattery/memorywire.
• Connectthe Blackwiretothegroundwire.
• Connectthe Redwiretotheaccessory/ignitionwire.
• ConnecttheOrangewiretotheilluminationwire.
Note: Iftheaftermarketradiodoesnothaveanilluminationwire,tapeupand
disregardtheOrangewire.
• Connectthe14-pinharnesstotheTYTO-01.
• Withallconnectionscompletedtotheaftermarketradio,plugthe20-pin
harnessintothevehicleswiringharness.
• Reconnectthenegativebatteryterminal.
• Cyclethekey,byturningtheignitiononfor30seconds.Thenoffandonagain
totesttheradio.
Installing the TYTO-01
• Turntheignitiononifnotalready,andthenturntheradioontoverifythatthe
radioworks.Checkbalanceandfadercontrolsforproperoperation.
• Toadjusttheoverallvolumeofyouraudiosystem,rotatethepotentiometer
whichislocatedonthe16-pinsideoftheinterfaceclockwise.
Testing the TYTO-01