Owner`s manual

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
• General
This unit fails to turn The power cable is not connected or the Connect the power cable firmly.
on or enters the plug is not completely inserted.
standby mode soon
afterthe poweris The speaker impedance setting is Set the speaker impedance to match your speakers. 21
turned on. incorrect.
The protection circuitry has been Make sure that all speaker wire connections on this 11
activated, unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
This unit has been exposed to a strong Set this unit to the standby mode, disconnect the --
external electric shock (such as lightning power cable, plug it back in after 30 seconds and then
or strong static electricity), use it normally.
No sound. Incorrect input or output cable Connect the cables properly. If the problem persists, 13-18
connections, the cables may be detective.
No appropriate Audio input jack select has Set an appropriate Audio input jack select. 34
been set.
Audio input jack select is set to "HDMI", Set Audio input jack select to "AUTO". 34
"COAX/OPT' or "ANALOG".
Audio input jack select is set to Set Audio input jack select to "AUTO" or 34
"ANALOG" while playing a source "COAX/OPT".
encoded in Dolby Digital or DTS.
No appropriate input source has been Select an appropriate input source with 33
selected. I_)INPUT <:1/ C> (or the input selector buttons(@)).
Speaker connections are not secure. Secure the connections. 11
The front speakers to be used have not Select the front speakers with @SPEAKERS. 33
been selected properly.
The volume is turned clown. Turn up the volume.
The sound is muted. Press @MUTE or @VOLUME +/- to resume audio 35
output and then adjust the volume.
Signals this unit cannot reproduce are Play a source whose signals can be reproduced by this --
being input from a source component, unit.
such as a CD-ROM.
The HDMI components connected to this Connect HDMI components that support the HDCP 14
unit do not support the HDCP copy copy protection standards.
protection standards.
"SUPPORT AUDIO" is set to "Other" and Set "SUPPORT AUDIO" to "HTR-6140" in 67
"HDMI" audio signals are not being "MANUAL SETUP".
played back on this unit.
78 En