Operation Manual

6
First use of the remote control
Before the first use of the remote control, the plastic tab should be pulled out of the
remote.
Axxion recommends using A-brand batteries.
Bright ambient light may interfere with operation of the remote control.
Remove the batteries from the remote control when it is not being used for a
long time.
Replacing the battery of the remote control
When the remote control stops working or stops working
properly, the battery should be replaced. Replace the battery as
follows:
1. Press the catch at arrow 1 in the direction of arrow 2 and
hold it.
2. Pull the battery tray out by pulling it in the direction of arrow
2.
3. Replace the battery with a new one and slide the battery tray
back in the remote control. Note that the + side of the battery
is facing up. The model number of the battery is CR2025.
POWER SUPPLY
Plug AC plug into the outlet socket for connecting the main power.
NOTE: If not any audio signal inputs to the unit in about 10 minutes, the unit will enter
to standby mode automatically (except at FM mode).
SLEEP TIMER SETTING
You can set the sleep timer at power on modes as following instructions:
During playback, press the SLEEP button on the remote control repeatedly to cycle
through the sleep time options, Release the SLEEP button when your desired sleep
time shows on the screen. Once the sleep time is expired, the unit will be switched
off.
During playback, press SLEEP button once to check the remaining sleep time.
HOW TO SET TIME
At the standby mode, press and hold the CLOCK button on the remote until Hour
flashes on the screen; use the TUNING/SKIP/SEARCH buttons on the remote to
adjust the hour and confirm your adjustment by pressing the CLOCK button on the
remote; Minute starts blinking on the screen, press the TUNING/SKIP/SEARCH